MDS TransNET 900 Specifications download pdf (Page 10)

viii MDS TransNET Ref. Manual MDS 05-2708A01, Rev. E

4. Installation, operation and maintenance of the transceiver should be in accordance with the

transceiver's installation manual, and the National Electrical Code.

5. Tampering or replacement with non-factory components may adversely affect the safe use of

the transceiver in hazardous locations, and may void the approval.

6. A power connector with screw-type retaining screws as supplied by MDS must be used.

When installed in a Class I, Div. 2, Groups A, B, C or D hazardous location, observe the fol-

lowing: WARNING —EXPLOSION HAZARD Do not disconnect equipment unless power

has been switched off or the area is know to be non-hazardous.

Refer to Articles 500 through 502 of the National Electrical Code (NFPA 70) for further infor-

mation on hazardous locations and approved Division 2 wiring methods.

FCC Part 15 Approval Notice

The MDS TransNET 900™ (FCC ID: E5MDS-EL805) and MDS TransNET 2400™ trans-

ceivers (Pending FCC ID: E5MDS-EL805-24) comply with Part 15 of the FCC Rules. Operation

is subject to the following two conditions: (1) this device may not cause harmful interference,

and (2) this device must accept any interference received, including interference that may cause

undesired operation. This device is specifically designed to be used under Section 15.247 of the

FCC Rules and Regulations. Any unauthorized modification or changes to this device without

the express approval of Microwave Data Systems may void the user’s authority to operate this

device. Furthermore, this device is intended to be used only when installed in accordance with

the instructions outlined in this manual. Failure to comply with these instructions may also void

the user’s authority to operate this device.

Manual Revision and Accuracy

While every reasonable effort has been made to ensure the accuracy of this manual, product

improvements may result in minor differences between the manual and the product shipped to

you. If you have additional questions or need an exact specification for a product, please contact

our Customer Service Team using the information at the back of this guide. In addition, manual

updates can often be found on the MDS Web site at

www.microwavedata.com.

ESD Notice

To prevent malfunction or damage to this radio, which may be caused by Electro-

static Discharge (ESD), the radio should be properly grounded by connection to the

ground stud on the rear panel. In addition, the installer or operator should follow

proper ESD precautions, such as touching a grounded bare metal object to dissipate

body charge, prior to adjusting front panel controls or connecting or disconnecting

cables on the front or rear panels.

Environmental Information

The equipment that you purchased has required the extraction and use of natural

resources for its production. Improper disposal may contaminate the environment and

present a health risk due to hazardous substances contained within. To avoid dissem-

ination of these substances into our environment, and to diminish the demand on nat-

ural resources, we encourage you to use the appropriate recycling systems for disposal. These

systems will reuse or recycle most of the materials found in this equipment in a sound way. Please

contact MDS or your supplier for more information on the proper disposal of this equipment.

Product Test Data Sheets

Test Data Sheets showing the original factory test results for this unit are available upon request

from the GE MDS Quality Leader. Contact the factory using the information at the back of this

manual. Serial numbers must be provided for each product where a Test Data Sheet is required.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 95 96

Comments to this Manuals

No comments

MDS TransNET 900 Specifications Page 10

Comments to this Manuals

Related products and manuals for Networking MDS TransNET 900