MDS TransNET 900 Specifications download pdf (Page 85)

MDS 05-2708A01, Rev. E MDS TransNET Ref. Manual i

INDEX

Accessories (table) 5

ADDR command (set/display radio network address) 29

Alarm

checking for 46

code definitions 47

codes 46

codes, table 47

major vs. minor 46

receiver timeout (RXTOT command) 40

reset output signal 29

set/display output sense (ASENSE command) 29

status (STAT command) 43

ALARM command (superseded; see STAT command) 43

Alarm Mask (AMASK) Command 29

Alarm Sense (ASENSE) Command 29

Alarm Status Command (STAT) 43

AMASK command (configure alarm output signal) 29

Antenna

installation 15

performance optimization 20

selection 9

SWR check 21

system gain vs. power output setting, table 13

Yagi, illustrated 10

ASENSE command (set/display alarm output sense) 29

BAUD command (set/display data interface port attributes) 29

Baud rate

setting 22

setting for RJ-11 DIAG port (DLINK command) 49

BUFF command (set/display received data handling mode) 30

Cable

data equipment to DATA INTERFACE connector 15, 22

data interface wiring for tail-end links 19

feedlines 10

maximum length, recommended 16, 71

Clear Zone Statisics Log, ZONE CLEAR 44

Clear-to-Send Delay (CTS) Command 31

Clear-to-Send Hold Time (CTSHOLD) Command 32

Clock-Synchronizing Master Address (CSADDR) Command 31

CODE command (display/set encryption value) 31

Command 36

TEMP (radio’s internal temperature reading) 43

Commands

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 95 96

Comments to this Manuals

No comments

MDS TransNET 900 Specifications Page 85

Comments to this Manuals

Related products and manuals for Networking MDS TransNET 900