MDS TransNET 900 Specifications download pdf (Page 50)

40 MDS TransNET Ref. Manual MDS 05-2708A01, Rev. E

Entering a RXD ON (0 ms default) or RXD XX will enable the function.

Entering

RXD OFF will disable the function and erase any stored value.

RXTOT [NONE, 0–1440]

Receive Data Timeout-Timer

This command sets or displays the amount of time (in minutes) to wait for the

next received data packet before issuing a receiver time-out alarm. The

default setting is

NONE.

SAF [ON, OFF]

Store-and-Forward Services Support

This command enables/disables the operation of the Store-and-Forward

services. It can be set only at the network’s Master station, but will effect all

radios in the associated network. The default setting is OFF. See related

commands: “XADDR [0–31]” on Page 44, “XPRI [0–31]” on Page 44, and

“XMAP [00000000-FFFFFFFF]” on Page 44.

SETUP

Setup Radio Test

This command sets up the transceiver for checking antenna SWR or trans-

mitter power with external measuring equipment. Do not use this mode

during normal operation.

When the

SETUP command is entered, the prompt changes to SETUP>, and:

• Hopping is disabled.

• Synthesizer frequencies are reset to the test frequencies specified by the

TX and RX commands described earlier.

• The radio can be keyed using the

KEY command. DKEY is used to unkey

the radio. (If the radio is left in a keyed state it is automatically unkeyed

after 10 minutes.)

• The

RSSI is sampled in a raw, continuous fashion regardless of whether

the unit is a Master or a Remote.

Entering

Q or QUIT returns the system to normal operation.

A timer keeps the Setup mode from accidentally leaving the system disabled.

After 10 minutes the system behaves as if

Q or QUIT had been entered,

returning the unit to normal operation.

NOTE: TransNET uses a automatic level control in normal operation to keep transmit

power constant over time. This facility is disabled in Setup mode. To test 1 Watt

power output in Setup mode, the user must enter PWR 30 followed by

KEY. The

power output will only be valid for the first couple of seconds.

SER

Radio Serial Number

Displays the serial number of the radio.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 95 96

Comments to this Manuals

No comments

MDS TransNET 900 Specifications Page 50

Comments to this Manuals

Related products and manuals for Networking MDS TransNET 900