MDS TransNET 900 Specifications download pdf (Page 38)

28 MDS TransNET Ref. Manual MDS 05-2708A01, Rev. E

6.3 Detailed Command Descriptions

The essential commands for most applications are Network Address (ADDR),

Mode (

MODE), and Baud Rate (BAUD). However, proper use of the additional

commands allows you to tailor the transceiver for a specific use, or to conduct

basic diagnostics on the radio. This section gives more detailed information

for the commands listed above in Section 6.2.

Most of the commands below can be used in two ways. First, you can type

only the command name (for example,

ADDR) to view the currently

programmed data. Second, you can set or change the existing data by typing

the command, followed by a space, and then the desired entry (for example,

ADDR 1234). In the descriptions which follow, allowable programming vari-

ables, if any, are shown in brackets [ ] following the command name.

XPRI

Details Page 44

Address of the primary Extended radio unit

(Extension).

XMAP

Details Page 44

Included Extended units in MODE X.

(Extensions and Remotes only).

XRSSI

Details Page 44

Minimum RSSI level required to preserve

synchronization with a non-primary radio.

(Only meaningful when XPRI is not NONE)

Table 11. Diagnostic and Test Functions

Command Description

KEY

Details Page 35

Enables the transmitter test.

(Must be in Setup mode. Details on page 40.)

DKEY

Details Page 33

Turns off the transmitter test.

(Must be in Setup mode. Details on page 40.)

TX [xxxx]

Details Page 43

Set/display transmit test frequency.

(Must be in Setup mode. Details on page 40.)

RX [xxxx]

Details Page 39

Set/display receive test frequency.

(Must be in Setup mode. Details on page 40.)

SETUP

Details Page 40

Enables Setup mode.

Times out after 10 minutes. Press “Q” to quit.

ZONE DATA

Details Page 44

Zone data statistics

ZONE CLEAR

Details Page 44

Clears the Zone Data log

Table 10. Operating Status—Display Only (Continued)

Command Description

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 95 96

Comments to this Manuals

No comments

MDS TransNET 900 Specifications Page 38

Comments to this Manuals

Related products and manuals for Networking MDS TransNET 900